1968 Gurney AAR Eagle
One of the stars of the recent Vintage Motor Racing exhibit
with a special tribute to Dan Gurney at the Lyon Air Museum was Dan Gurney’s
own 1968 Eagle race car.
The 1968 Eagle chassis designed by former Lola engineer Tony
Southgate featured a lower flatter nose due to the use of outboard suspension
assemblies. The car’s main tub was also lower in profile, with a laid-back
windscreen and a body/engine cover which ended with a squared off tail section
instead of the earlier rounded tail used in the 1966 and 1967 Eagle designs.
There were five 1968 Eagles built by All American Racers on
Santa Ana California in the 33-car starting field for the 1968 Indianapolis
500-mile race, First was the featured
car owned by Gurney’s primary sponsor Oscar L “Ozzie” Olson of the Olsonite
Corporation, manufacturer of molded one-piece plastic toilet seats.
Gurney’s
entry was powered by a 303-cubic inch stock-block Ford V-8 engine fitted with Gurney-Weslake
Mark Four cylinder heads. For qualifying with the addition of nitromethane to
the alcohol fuel the Gurney-Weslake engine could develop 525 horsepower.
1968 was the height of innovation at the Indianapolis Motor
Speedway which was reflected in the variety of powerplants fitted to the other
AAR Eagles that were entered. Roger McCluskey drove an Eagle owned by Atlanta
sportsman Lindsey Hopkins that was powered by a 159-cubic inch 4-cylinder
Offenhauser engine fitted with a turbocharger which was sponsored by G C Murphy
stores.
Bobby Unser drove a similar chassis and engine combination owned by Bob
Wilke’s Leader Card Racers with sponsorship from Rislone oil treatment. IN
1968, a turbocharged Offehauser engine could develop 625 horsepower in
qualifying trim.
Gurney’s teammate on the Olsonite team for the ‘500” would
be 1967 Formula One world champion Denis Hulme who became available after his
original entry, the Shelby-Wallis turbine powered machine was withdrawn. Hulme
drove the #42 Olsonite AAR Eagle which was powered a conventional 255-cubic
inch DOHC (double overhead camshaft) Ford V-8 engine.
The last Eagle entry in the Indianapolis 500-mile race field
was owned by PSA airline heir Tom Friedkin powered by a 159-cubic inch
turbocharged DOHC Ford engine driven by Jerry Grant with sponsorship from
Bardahl oil treatment.
While it could potentially produce the highest
horsepower of the available engine, at high boost levels, the Schwitzer
turbocharged Ford engine suffered both head gasket and fuel distribution issues
which resulted in burned pistons.
In qualifying time trials, Unser led the Eagle contingent as he started
third, on the outside of the front row, with McCluskey next in seventh place. Gurney
himself started the 1968 ‘500’ in tenth place, while Grant started fifteenth,
and Hulme in a late-developing program started in twentieth place.
After the leading STP Lotus turbines broke with nine laps
left in the race, Bobby Unser lead the final nine laps and won by 53.81 seconds
over Gurney. In a stunning debut, the 1968 AAR Eagles swept three of the top
five finishing positions as Hulme finished in fourth place.
Two weeks later at the mid-June 1968 two-heat ‘Telegraph
Trophy 200’ at the Mosport International Raceway in Bowmanville Ontario Canada,
Gurney and his Eagle swept the program.
A new 1968 Eagle powered by a 305-cubic inch Chevrolet V-8 stock-block engine built by Traco Engineering was entered for the event by Roger Penske for sports car ace Mark Donohue which finished in the top five of both heat races. This marked Penske’s first Indianapolis type racing car entry.
Gurney started from the pole position
with a 110 MPH (mile per hour) average speed around the 2.5-mile road course.
At the drop of the green flag, Dan led all forty laps of the first heat as
Indianapolis ‘500’ winner Bobby Unser crashed his 1968 Eagle on the first
lap. In the second Mosport heat with only 15
starters, Gurney again dominated from the pole position,as he led every lap and
finished the 100-mile heat race in 55 minutes.
Gurney did not race his Eagle Indy Car again for five and
half months as he next appeared at the 1968 United States Auto Club (USAC)
season finale at the Riverside International Raceway for the ‘Rex Mays 300.’
Gurney qualified the AAR Eagle now fitted with stubby front wings on the nose
and a rudimentary wing that spanned across the rear exhaust pipes, qualified
for the pole position with an average speed of 118-1/2 MPH around the historic
2.6-mile road course.
Gurney led the first four laps of the race, before Mario
Andretti in a tight battle for the 1968 USAC national championship led the next
four circuits. Gurney surged back into the lead on lap nine and never looked back
as he led the remaining 108 laps and won by a lap over Bobby Unser’s 1968 Eagle
which had been repaired from its Mosport damage and fitted with a DOHC Ford
engine.
The #48 Olsonite AAR Eagle raced five times during the 1968 USAC season and scored three victories and one second place result was displayed at the Lyon Air Museum as it
appeared at its final race as a tribute to Dan Gurney who passed away on
January 14 2018.
Great tips, many thanks for sharing. I have printed and will stick on the wall! I like this blog.
ReplyDeleteSpeed-Garage
Nicely written article. So very informative. Thank you. This was the grand era of Championship racing. So many unique variances to the engines and cars. Great pictures. What a nice place for a tribute. Notice the angle of the front springs. So glad you went and shared. I recall the start that year and as they rolled off all those Gurney cars not comprehending the effort behind each until now.
ReplyDeleteThank you.
Delete